Effectivity 912/914 Series
Edition 1 / Rev. 3
page 29
October 01/2010
d04777
73-00-00
BRP-Powertrain
Maintenance Manual
3.3.7)
Float chamber, floats
See Figs. 73-17, 73-18, 73-19 and 73-20.
On the 912 Series:
Release the spring clip (39). See Fig. 73-13.
On the 914 Series:
Remove the safety wiring and the end screw (1)
with the sealing ring (2) 16x22x1. Tightening
torque 5.5 Nm (48.7 in.lb)
Remove and clean the float housing (11) with the seal (12).
Check both floats (9) for free movement on the guide pin (3). When the
float is at its lowest position, it still must have radial clearance and must
not stick on the float chamber wall (10).
■
CAUTION: A stuck float causes the carburetor to flood.
Check the wear on the guide sleeves (5) inserted in the float. Check the
pins (6) for the float support (7) for wear caused by excessive vibration.
If there is noticeable wear, replace both floats and if necessary also the
float brackets (8).
07715
07716
Fig. 73-18
Fig. 73-17
11
12
6
7
8
9
10
1
2
3
5
Summary of Contents for MMH-912 Series
Page 463: ......
