page 76
May 01/2007
Effectivity: 912 Series
Edition 1 / Rev. 0
d04055
INSTALLATION MANUAL
BRP-Rotax
13.6) Feasible position and location of the oil tank
See Fig. 50.
-
The longitudinal axis z3 to be parallel to z-axis of the system of coordinates.
Tolerated deviation of parallelism: ± 10°
◆
NOTE:
Above notice is valid for both planes.
The oil tank (1) has to be positioned in its z-axis such that the normal oil level
(2) is always between 0 and -400 mm (-15.75 in.) on the z-axis .
◆
NOTE:
The profile clamp of oil tank should be between 0 mm and -360
mm below the center line of the propeller shaft.
▲
WARNING:
At higher location of the oil tank oil might trickle through
clearances at bearings into crankcase during longer periods of
engine stop. If fitted too low it might badly effect the oil circuit.
-
Install the oil tank free of vibrations and not directly to the engine.
-
Oil tank cover (3) and oil drain screw (4) to be easily accessible.
Fig. 50
09162
5
3
5
4
1
2
