Ross nielsen NWE-IP, User Manual, Page: 71 / 80

NWE-IP User Guide (v5.0) DashBoard Interface Overview • 71
Status Tab
Table 16.12 summarizes the read-only information displayed in the Status tab.
Device Setup Tab
Table 16.13 summarizes the read-only information displayed in the Device Setup tab.
NWE Channel <blank> The specified stream is not assigned to an output of
the NWE-IP
Output #, CH # Assigns the audio stream to a watermark engine of
the NWE-IP
Table 16.12 Status Tab
Item Parameters Description
Stream Name <text> Displays the unique identifier assigned to the
specified AES67 stream
Packets Sent # Specifies the number of packets sent on the output
for the specified stream
Buffer Level # The number of packets stored in the NWE-IP
buffer for the specified stream
Buffer Underrun # Specifies the number of under runs of the sender
buffer
Packets Lost # The number of packets lost by the specified stream
Session Name <text> Reports the unique name for the Sender session
Table 16.13 Device Setup Tab
Item Parameters Description
Packet Time # Adds an offset to the audio streams if you suspect
the audio packets may be received out of order or
delayed.
This impacts all connected audio stream. It is
recommended to set the Packet Time before
configuring your network streams.
Default # Channels # Defines the default number of audio channels
available for configuration. You can still specify a
value other than the default for each individual
stream.
CODEC (read-only) L24 Specifies the Real-time Transport Protocol (RTP)
the NWE-IP uses for delivering audio over the
network
L16
Table 16.11 Network Streams Tab
Item Parameters Description