Ross nielsen NWE-IP, User Manual, Page: 61 / 80

NWE-IP User Guide (v5.0) DashBoard Interface Overview • 61
Current Time
(read-only)
# Reports the current time as reported by your
system clock
Profile AES Specifies that the NWE-IP timing uses the AES67
Media standard
SMPTE Specifies that the NWE-IP timing uses the SMPTE
ST 2059-2 standards. This is the recommended
setting.
Default Specifies that the NWE-IP timing uses the
IEEE1588 Default profile standards.
Free-running The NWE-IP automatically selects the timing
profile based on the detected stream
Slave Only (read-only) Selected Defines the NWE-IP as a slave only device in the
system; the NWE-IP cannot be used as a
Grandmaster or Master device
Domain # Specifies that the NWE-IP is within the group of
clocks in your network
Priority 1 # Assigns the first priority level to the NWE-IP
during a Grandmaster election where a value of:
• 1 is the highest priority
• 255 is the lowest priority
This menu is applicable when the Slave Only box
is not selected.
Priority 2 # Assigns the secondary priority level to the
NWE-IP during a Grandmaster election where a
value of:
• 1 is the highest priority
• 255 is the lowest priority
This menu is applicable when the Slave Only box
is not selected.
Sync Interval # Specifies how often the NWE-IP sends Sync
messages
Announce Interval # Specifies how often the NWE-IP sends Announce
messages
Announce Receipt
Timeout
# Controls how long the NWE-IP will wait before
declaring the Grandmaster absent and initiating a
new election
NET#
Steps Removed
(read-only)
# Specifies the number of communication paths to
the Grandmaster clock
Offset from Master
(read-only)
# Specifies the last measured time offset from the
master in number of nanoseconds
Mean Path Delay
(read-only)
# Average time in nanoseconds it takes a packet to
traverse end to end from the PTP master
Table 16.2 Timing Tab
Item Parameters Description