Ross nielsen NWE-IP, User Manual, Page: 39 / 80

NWE-IP User Guide (v5.0) Configuring the AES67 Receiver • 39
Configuring the AES67 Receiver
This chapter outlines the steps required to configuring and allocate the AES67 receiver streams to Watermark
Encoder channels on the NWE-IP.
Overview
From DashBoard you defining audio streams that provide AES67 data (including the IP Address of each stream and
the number of audio channels it includes) then map the streams to create Network Stream groups. Each Network
Stream group can then be allocated as a source for a Watermark Encoder channel.
The following steps are required:
1. Configure the AES67 Receiver global settings.
2. Define the Network Stream group(s) that will provide the AES67 data to be encoded.
3. Route each Network Stream group to a Watermark Encoder channel.
Configure the Global AES67 Receiver Settings
There are two settings that impact all AES67 Receiver streams on the NWE-IP: the default number of (audio)
channels, and specify a Link Offset. These settings are located on the Device Setup tab in the AES67 Receiver
interface.
To define the default number of audio channels for the AES67 Receiver
1. Display the AES67 Receiver interface in DashBoard as outlined in “ To display the NWE-IP interfaces in
DashBoard ” on page 29.
2. Select the Device Setup tab.
3. Use the Default # Channels field to specify the number of audio channels available to map for any network
stream group for the AES67 Receiver.