Ross nielsen NWE-IP, User Manual, Page: 65 / 80

NWE-IP User Guide (v5.0) DashBoard Interface Overview • 65
Stream Groups Area
The Stream Groups area is located on the bottom half of the Connections tab. From this area you can route any
source signal to an output. Each button displayed here represents a configured network stream.
 Once a Watermark Output is selected, clicking a
Stream Group
button performs an immediate switch (a
hot-punch). In the example below,
Server10
was selected.
Table 16.5 Connections Tab — Outputs Area
Item Parameters Description
Output Name # Each button represents an output that is configured
and available for switching
Source (read-only) # Indicates the network stream currently used by the
specified output.
Select an Audio button to specify an audio-only
receiver for a breakaway
Status (read-only) OK (Green) No errors are detected on this output
Off (Green) This SDI output is disabled
Alarm Suppressed (Green) An alarm condition is present, but the alarm is
disabled on the Alarm Enable tab
Network Delay Too Big
(Yellow)
The link offset selected by the user is smaller than
the propagation delay of the network
No packets received
(Yellow)
The configured destination IP stream(s) is not
receiving any packets; stream might not be on the
network or experiencing other issues
Status (read-only) System clock is in failure
(Red)
The NWE-IP is unable to re-obtain a stable clock
source. Sessions cannot be created until this
condition is fixed.
It is recommended to navigate to the Advanced >
Timing > PTP tab to check the status of the PTP
and update the Configuration settings.
Once PTP is locked again, the Network Groups
will need to be disconnected and then re-connected
to clear the alarm.
Param Out of Range (Red) One of the following is occurring:
• A Destination was configured with an invalid
setting
• Two receivers with the same network stream
were created. NWE-IP can only subscribe to a
stream once.
Connection (read-only) Connection was successful Indicates the connection status between the
selected input and output
Not in Use
<blank>