Rosco CubeConnect, User Manual

Page: 11 / 37

Basic Operation
11
Apply power (5VDC) to CubeConnect™ Transceiver (the Blue Power Indicator
will illuminate). Select desired mode using MODE SELECT BUTTON . The
current Mode will be shown on the mode LEDs. Connect a lighting control
device to the DMX IN, Bluetooth*, or DB9 Serial input, depending on the mode
selected. Put the wireless lights being controlled into "SERIAL" mode and set
up their "Serial Address" (1-254 allowed). Begin sending data from the source
device to control the wireless lights. Data sent to the DMX input must conform
to the DMX512 protocol. Data sent to the BlueTooth Module or DB9 Serial
input must conform to the "MINI-SSC" protocol which is sent out at the
standard 9600 baud rate. Make sure you are sending data to the same channel
numbers that the wireless lights are programmed for.
In the modes LOCKED, BLUETOOTH IN*, and DB9 SERIAL IN, the unit outputs
the lighting data to both the DMX OUTPUT and to the wireless antenna. In the
WIRELESS IN mode, data is sent out only on DMX OUT. In the DMX IN mode,
data is sent out only on the wireless antenna.
The four channels of diagnostic indicators on the left side of the unit respond
to channels 1, 2, 3, and 4 input data. This allows some troubleshooting
capability to see if the data input is working.
*Bluetooth Technology Coming Soon