Rosco CubeConnect, User Manual

Page: 24 / 37

Multiple Wireless Transceivers
24
If there are three Transceivers present, the Master starts the transmitting, the
1st Slave listens to the Master and begins transmitting when the Master is
done, the 2nd Slave listens to the 1st Slave, and begins transmitting when
the first Slave is done. The Master’s built in delay is set to accommodate the
time for both Slaves to finish before allowing the Master to transmit again.
To access Master/Slave settings, the Transceiver must be hard powered from
off to on while the
MODE SELECT BUTTON
is held in. When you do this, two
things will happen:
1)
The top two MODE LEDS will illuminate indicating you are in the
Master/Slave setup mode
2) The diagnostic indicators show the current Master/Slave setting (See pg.20)
You can now use the
MODE SELECT BUTTON
to select the Master/Slave
setting that's desired. Turn the Transceiver off & back on to discontinue
Master/Slave setup and resume normal operation.
NOTE:
The current Master/Slave settings are briefly shown on the diagnostic
LEDs during the Transceiver boot-up sequence