Rosco CubeConnect, User Manual

Page: 30 / 37

Basic Operation
30
(Non-Networked - Network Slide Switch Set to Off)
Apply power to the MIRO/BRAQ Cube™ you will be using with the Dongle, and
put it into Serial Mode via the Change Operate Mode menu choice. If “Serial
Mode” does not come up as a choice, it needs to be enabled. (To enable
“Serial Mode” select the Factory Setup menu choice and enter the password
3270 . Use the MENU key to go to the “Enable Serial Mode" screen, and push
OK
. Use
MENU
key to Exit Factory Setup, and "Serial Mode" should now be
accessible in the Change Operate Mode menu choice. Put the MIRO/BRAQ into
Serial Mode.)
Set the "Serial Address" to the desired fixture address. Addressing in Serial
Mode is similar to addressing in DMX mode. With a 4C fixture, the selected
address will be the Red Channel, with subsequent channels controlling Green,
Blue, and White. For simplicity, set the Serial Address = 001 for now. With a
WNC fixture, the selected address will be the Warm channel with subsequent
channels controlling Neutral and Cool. With the Dongle unplugged from the
MIRO/BRAQ Cube™, remove the End Cap and set the Network Mode Switch to
the OFF position. With the MIRO/BRAQ Cube™ powered up, plug the Dongle
into the DMX IN XLR connector and the blue Power/Learn Indicator on the
Dongle should illuminate.