Rosco CubeConnect, User Manual

Page: 32 / 37

Network Operation
32
(Network Slide Switch Set to On)
In cases where the now wireless MIRO/BRAQ is blocked by a structure, or is
physically too far away from the Transceiver for reliable data transmission, a
second (or even a third) Transceiver can be used in an installation. Care must
be used when using multiple CubeConnect™ Transceivers because they will
interfere with each other if not set up properly. Only use multiple Transceivers
when necessary.
If multiple Transceivers are necessary, there are setup functions built into the
Transceivers to insure that they won't interfere with each other. See the users
guide for Transceivers for more information on using multiple wireless
Transceivers.
When using more than one Transceiver in an installation, the dongles must be
"paired" (learned) to the Transceiver intended for it. To pair a Dongle to a
Transceiver, use the following procedure:
1) Make sure the Transceiver you are pairing to is turned on and is in the
"Dongle Pair" mode. Also make sure there is not another Transceiver nearby
that is turned on.
2)
Remove the Dongle from the MIRO/BRAQ