Accura 2300/2350 User Guide
Chapter 4 Accura 2300 Operation/Setup
ⓒ
2011 Rootech Inc. All Rights Reserved
Page 131
Accura 2350 Module ID Selection
Accura 2300 selects Module ID[UNIT ID] of Accura 2350 to display measurement values on LCD among
many Accura 2350s which are communicating with Accura 2300. In display mode, if press ENTER button long,
Module ID on the upper left will blink at 0.4 second intervals, and Module ID can be changed by UP/DOWN
button. If you want to assign the Module ID to the changed value, press ENTER button long again. Accura
2350 Module ID is used as the communication ID for RS-485 communications with Accura 2300.
Fig 4.7 Accura 2350 Module ID Selection at upper part of LCD Screen
Button Operation
Button
Description
[Display Mode]
Press
1
Select display mode.
[Module ID Selection]
Long press
2
Make the Module ID[UNIT ID] possible to be changed[blink].
Press
Select Module ID to display
3
.
Long press or
press
Set the changed Module ID and move to display mode[blink
stops].
1. When the button is pressed, "Beep" sounds.
2. Press for more than 1 sec. After one second, "Beep" sounds.
3. Each time Module ID is changed, measurements of Accura 2350 of the Module ID are displayed on LCD screen.
Note
The Module ID [UNIT ID] blinks when:
①
1.2 second interval: In case that Accura 2300 cannot communicate with Accura 2350.
- disconnection of 6C telephone line
- changing of Module ID
- conflicting ID with Module ID
②
0.4 second interval: In case that Module ID is possible to be changed.
Summary of Contents for Accura 2300 Front
Page 221: ......
