RML-1
PROGRAMING GUIDELINE
- 9 -
D [terminator]
<Type>
xn: float
yn: float
<Parameter Range>
-8388608.0
䌾
8388607.0
<Description>
This sequentially cuts line segments between coordinates specified from
the present tool location, in the sequence x1,y1, x2,y2,..., xn,yn. The
coordinate values are all absolute coordinates. Thereafter the system is in
the absolute-coordinate mode.
<Errors>
For the parameters, a pair of values, x and y, constitute a single set, and
more than one set may be stated.
When the number of parameters is odd, each pair is sequentially
interpreted from the beginning as x and y and is executed accordingly, and
the final remaining odd value generates error 2. Execution is not
performed.
I
(Relative draw -- Relative-coordinate line-cutting command)
<Format>
I dx1, dy1, dx2, dy2,..., dxn, dyn[terminator]
I [terminator]
<Type>
float
<Parameter Range>
-8388608.0
䌾
8388607.0
<Description>
This performs cutting at the Z1 height from the present tool position to the
coordinates specified by the amount of change along the X axis dx1 and
the amount of change along the Y axis dy1. It next performs cutting at the
Z1 height from the position moved to, to the coordinates specified by the
amounts of change dy1, dy2 for the corresponding X and Y axes. This
sequentially performs cutting up through the final specified coordinates.
This cuts line segments between coordinates.
The coordinate values are all relative coordinates, and the system goes
into the relative-coordinate mode.