RML-1
PROGRAMING GUIDELINE
- 21 -
When the value of the parameter is the model's capacity or lower, the
model's minimum speed is used.
The given parameter value is not guaranteed to be reached in actual
operation.
Depending on the length of the line segment, operation may be slower
than the value specified by the parameter because of an inability to
accelerate fully.
Also, even when acceleration is possible, the specified speed may not
necessarily be accurately reached; accuracy may be low.
Examples for some models:
VS 0 may be 0.5 mm/sec.
VS 0.1 to VS 1.0 may be in increments of 0.1 mm/sec.
Values of VS 1.0 or higher may be in increments of 1 mm/sec.
The default value may be, for example, 2 mm/sec.
<Errors>
No error is generated.
<Other Matters>
3-3;Commands Common to Mode 1 and Mode 2
!DW
(Dwell -- Command to specify dwell)
<Format>
!DW dwell-time [terminator]
!DW [terminator]
<Type>
int
<Parameter Range>
0
䌾
32767msec
<Description>
When a parameter is given, if it is a settable value, then dwell (waiting) for
the time set by the value is performed when the cutting direction changes.
When !DW is used without a parameter, the default value is applied (0
