RML-1
PROGRAMING GUIDELINE
- 26 -
<Errors>
A negative parameter (less than 0) results in error 3.
Parameters exceeding 8388607 also result in error 3 and no execution.
!VZ
(Velocity select Z axis -- Z-axis feed rate setting command)
<Format>
!VZ s [terminator]
!V [terminator]
<Type>
Basically int
A value that is a decimal fraction, such as !VZ 0.5, must be type float in
order to be achieved.
<Parameter range>
-32768 to 32767 [mm/sec]
<Description>
This sets the speed relationship when the tool moves along the Z axis or
when movement is performed using the three-axis simultaneous-
movement command.
!VZ without a parameter is set to the default speed.
When a parameter is present and is a settable speed, the speed is set to
the value of the parameter.
When not a settable value, the maximum or minimum settable value is set
automatically.
On some models, !VZ 0 may be, for example, 0.5 mm/sec.
The default value may be, for example, 2 mm/sec.
<Errors>
An out-of-range parameter results in error 3.
When the parameter is within range, no error occurs even if its value
cannot be set on the particular model.
<Other Matters>
