RML-1
PROGRAMING GUIDELINE
- 13 -
There is no change before and after command execution in the XY origin
point or in the value of Z0 set using the control panel.
F
(Velocity XY axis -- X- and Y-direction speed setting command)
<Format>
F tool-speed [terminator]
F [terminator]
<Type>
Basically int
float for noninteger values such as F 0.5
<Parameter Range>
-32768
䌾
32767 [mm/sec]
<Description>
F without a parameter is set to the default speed.
When a parameter is present and is a settable speed, the speed is set to
the value of the parameter.
When the value of the parameter is the model's capacity or higher, the
model's Maximum speed is used.
When the value of the parameter is the model's capacity or lower, the
model's minimum speed is used.
In operation, achieving the actual given parameter value cannot be
guaranteed.
Depending on the length of the line segment, operation may be slower
than the value specified by the parameter because of an inability to
accelerate fully.
Also, even when full acceleration is possible, the specified speed may not
necessarily be accurately reached; precision may be low.
Examples for some models:
F 0 may be 0.5 mm/sec.
F 0.1 to F 1.0 may be in increments of 0.1 mm/sec.
Values of F 1.0 or higher may be in increments of 1 mm/sec.
The default value may be, for example, 2 mm/sec.
<Errors>
No error is generated.
<Other Matters>
