Roland Juno-Stage, User Manual

Page: 22 / 256

22
Getting Ready
941
Once the connections have been completed (p. 19), turn on
power to your various devices in the order specified. By turning
on devices in the wrong order, you risk causing malfunction and/
or damage to speakers and other devices.
1. Before turning on the JUNO-STAGE’s power, consider these two
questions:
• Are all devices connected properly?
• Have the volume controls of the JUNO-STAGE and all connected
audio devices been turned to their lowest settings?
2.
Turn on the [POWER] switch located on the rear panel of the
JUNO-STAGE.
942
This unit is equipped with a protection circuit. A brief interval (a
few seconds) after power up is required before the unit will
operate normally.
To ensure proper operation of the pitch bend lever, make sure
not to touch the lever when turning the JUNO-STAGE’s power on.
3. Turn on the power for any connected audio devices.
4. While playing the keyboard and listening to the sound, slowly
increase the volume of the JUNO-STAGE and the volume of the
connected equipment until you obtain the desired volume.
fig.Volume
1.
Before turning off the power, consider these two questions:
• Have the volume controls of the JUNO-STAGE and all connected
audio devices been turned to their lowest settings?
• Have you saved your JUNO-STAGE sounds or other data you’ve
created?
2.
Turn off the power for all connected audio devices.
3.
Turn off the [POWER] switch of the JUNO-STAGE.
fig.volume.epsj
1. Use the [VOLUME] knob to adjust the volume.
Turning the knob toward the left will decrease the volume, and
turning it toward the right will increase the volume.
Also adjust the connected device to an appropriate volume.
The characters in the display may be difficult to view immediately after
turning on the JUNO-STAGE’s power or after extended use. If this
occurs, turn the rear panel [LCD CONTRAST] knob to make the
display legible.
You can use the included USB memory protector to prevent theft of the
USB memory connected to the JUNO-STAGE.
fig.CoverLock.eps
Caution
• You must use the included screws.
• You must use the included Allen wrench to tighten or remove the
screws. Using a tool that does not match the screw heads will
damage them.
• Be careful not to over-tighten the screws. Doing so may damage
the screw’s head, causing the wrench to rotate uselessly.
• To tighten the screws, turn the Allen wrench clockwise. To loosen
the screws, turn the Allen wrench counter-clockwise.
fig.Screw.e
• Keep the removed screws out of the reach of small children to
ensure they are not swallowed accidentally.
Turning On/Off the Power
Turning Off the Power
Do not touch!
Adjusting the Volume Level
Adjusting the Display Contrast
([LCD CONTRAST] Knob)
Using the Included USB Memory
Protector
tighten loosen
JUNO-STAGE_e.book 22 ページ ２００８年１０月１７日 金曜日 午後１２時２７分