Roland Juno-Stage, User Manual

Page: 142 / 256

142
Chapter 10. Detailed Editing for Performances
[PAGE
↓
] - [2 (OFFSET)]
The values set here are applied to the parameters of the patches/rhythm sets of the various parts, and are used in correcting the tone.
[PAGE
↓
] - [3 (VIBRATO)]
[PAGE
↓
] - [4 (KEYBORD)]
Parameter Value Explanation
Cutoff -64–+63 Adjusts the cutoff frequency for the patch or rhythm set assigned to a part.
Reso -64–+63 Adjusts the Resonance for the patch or rhythm set assigned to a part.
Attack -64–+63 Adjusts the TVA/TVF Envelope Attack Time for the patch or rhythm set assigned to a part.
Releas -64–+63 Adjusts the TVA/TVF Envelope Release Time for the patch or rhythm set assigned to a part.
Decay -64–+63 Adjusts the TVA/TVF Envelope Decay Time for the patch or rhythm set assigned to a part.
Parameter Value Explanation
Vib Rate -64–+63 For each part, adjust the vibrato speed.
Depth -64–+63 For each part, this adjusts the depth of the vibrato effect.
Delay -64–+63 For each part, this adjusts the time delay until the vibrato.
Phase OFF, ON
Set to “ON” when you want to suppress discrepancies in timing of parts played on the same MIDI
channel.
* When this parameter is set to “ON,” parts on the same MIDI channel are put in a condition in
which their timing is matched, enabling them to be played at the same time. Accordingly, a
certain amount of time may elapse between reception of the Note messages and playing of the
sounds. Turn this setting to “ON” only as needed.
Parameter Value Explanation
Kbd OFF, ON (
✔
)
Specifies, for each part, whether or not the keyboard controller section will be connected to the
internal sound generator.
K.L C - –(Upper) Lowest note that the tone will sound for each part
K.U
(Lower)–G9
Highest note that the tone will sound for each part
When the Key Range (p. 102) is set for each individual tone in a patch, sounds are produced
in the range where the Key Range of each tone and the Key Range for the part overlap.
Velo -63–+63
Changes the volume and cutoff frequency for each part according to the velocity with which the
keys are pressed.
If you want strongly played notes to raise the volume/cutoff frequency, set this parameter to
positive (+) settings. If you want strongly played notes to lower the volume/cutoff frequency,
use negative (-) settings.
Curve OFF, 1–4
Velocity curve for each MIDI channel
Selects for each MIDI channel one of the four following Velocity Curve types that best matches
the touch of the connected MIDI keyboard.
Set this to “OFF” if you are using the MIDI keyboard’s own velocity curve.
Voice 0–63, FULL
This setting specifies the number of voices that will be reserved for each part when more than 128
voices are played simultaneously.
* It is not possible for the settings of all parts to total an amount greater than 64. The remaining
number of available voices will be displayed at (rest=). Pay attention to this readout as you
make Voice Reserve settings.
Ch 1–16 MIDI receive channel for each part
Key range specified for Performance
Key range specified for Patch
The range in which notes will play
2 1 3 4
JUNO-STAGE_e.book 142 ページ ２００８年１０月１７日 金曜日 午後１２時２７分