Roland Juno-Stage User Manual Download

Page: 111 / 256

111

Chapter 8. Detailed Editing for Patches

MISC

Tone Delay

This produces a time delay between the moment a key is pressed (or released), and the moment the tone actually begins to sound. You can also
make settings that shift the timing at which each tone is sounded. This differs from the Delay in the internal effects, in that by changing the sound
qualities of the delayed tones and changing the pitch for each tone, you can also perform arpeggio-like passages just by pressing one key.

You can also synchronize the tone delay time to the tempo of the JUNO-STAGE.

* If you are not going to use Tone Delay, set the Tone Delay Mode parameter to “NORM” and Delay Time parameter to “0.”

* If “Struct 1 & 2, 3 & 4” (p. 99) is set to TYPE 02–10, the settings for tone 1 (3) will follow the settings of tone 2 (4). (This is because the outputs

of tones 1 and 2 are combined into tone 2, and the outputs of tones 3 and 4 are combined into tone 4.)

fig.ToneDly1.e

CTRL 1–4
Sens 1–4

-63–+63

Amount of the Matrix Control’s effect that is applied

• If you wish to modify the selected parameter in a positive (+) direction—i.e., a higher value,

toward the right, or faster etc.—from its current setting, select a positive (+) value.

• If you wish to modify the selected parameter in a negative (-) direction—i.e., a lower value,

toward the left, or slower etc.—from its current setting, select a negative (-) value.

• For either positive or negative settings, greater absolute values will allow greater amounts of

change. Set this to “0” if you don’t want to apply the effect.

CTRL 1–4
Switch 1–4

OFF, ON, REVS

Tone to which the effect is applied when using the Matrix Control

OFF:

The effect will not be applied.

ON:

The effect will be applied.

REVS:

The effect will be applied in reverse.

Parameter

Value

Explanation

Tone Delay Mode

NORM, HOLD,
OFFN, OFFD

Type of tone delay

NORM:

The tone begins to play after the time specified in the Tone Delay Time parameter has

elapsed.

HOLD:

Although the tone begins to play after the time specified in the Tone Delay Time

parameter has elapsed, if the key is released before the time specified in the Tone Delay Time
parameter has elapsed, the tone is not played.

OFFN:

Rather than being played while the key is pressed, the tone begins to play once the

period of time specified in the Tone Delay Time parameter has elapsed after release of the key.
This is effective in situations such as when simulating noises from guitars and other instruments.

OFFD:

Rather than being played while the key is pressed, the tone begins to play once the

period of time specified in the Tone Delay Time parameter has elapsed after release of the key.
Here, however, changes in the TVA Envelope begin while the key is pressed, which in many
cases means that only the sound from the release portion of the envelope is heard.

* If you have selected a waveform that is a decay-type sound (i.e., a sound that fades away

naturally even if the key is not released), selecting “OFFN” or “OFFD” may result in no sound
being heard.

Tone Delay Time

0–127, Note

Time from when the key is pressed (or if the Tone Delay Mode parameter is set to “OFFN” or
“OFFD,” the time from when the key is released) until when the tone will sound

Specify this as a note value if you want to synchronize the delay to the tempo of the
JUNO-STAGE.

Parameter

Value

Explanation

Note off

Delay time

Note on

Tone Delay Mode: NORM

No Tone Delay

Note off

Delay time

Note on