Roland CX-300, User Manual

Page: 5 / 64

5
3-1 Setting Up
3 Setup
Unpacking, installing, or relocating
the unit are operations which must
be carried out by two or more per-
sons holding the unit at its bottom
surface on the left and right sides.
Failure to do so may result in dropping the
unit, leading to injury.
Use care to avoid pinching the
fingers when placing the unit on the
stand.
Doing so may result in injury.
Use the joining screws to secure the
unit to the stand.
Failure to do so may result in falling of the
unit, leading to injury.
NOTICE
Never install this unit in any of the following situations, as it could result in damage:
Places where the installation surface is unstable or not level.
Places with excessive electrical noise.
Places with excessive humidity or dust.
Places with poor ventilation, because the CX-500/400/300 generates considerable heat during operation.
Places with excessive vibration.
Release the caster locks for the
stand before attempting to move.
Otherwise the unit may tip over and cause
injury.
Install in a level and stable location.
Otherwise the unit may tip over and cause
injury.
For an explanation of how to assemble the unit and the stand (PNS-502/402/302), refer to the “ASSEMBLY INSTRUCTIONS”
included with the stand.
When using the unit while mounted on a stand, be sure to ensure a
sufficient amount of installation space for the unit. The required installa-
tion spaces for each model are listed below.
CX-500 : 1200 mm (47-1/4 in.) high, 1700 mm (66-15/16 in.) wide,
and 900 mm (35-7/16 in.) depth
CX-400 : 1200 mm (47-1/4 in.) high, 1500 mm (59-1/16 in.) wide,
and 900 mm (35-7/16 in.) depth
CX-300 : 1200 mm (47-1/4 in.) high, 1250 mm (49-1/4 in.) wide,
and 900 mm (35-7/16 in.) depth
The material moves while cutting is in progress. Objects which may
obstruct material movement must not be placed within 60 cm (23-5/8 in.)
to the front or rear of the unit.
600mm
(23-5/8 in.)
600mm
(23-5/8 in.)