Interfaces and Connectors
R&S
®
DVMS4
15
Getting Started 2113.7625.02 ─ 10
3.2
Rear Panel
This chapter gives a short overview of the connectors on the rear panel.
The R&S
DVMS provides 4 slots for the installation of modules. The slots are not pre-
assigned to a certain module. The modules can be installed in any slot in any combina-
tion. See the R&S
DVMS data sheet for an overview of the currently available mod-
ules.
The [MODULE INDEX] shows how the slots are assigned by the R&S
DVMS firmware.
Further information:
●
Instrument configuration: see the user manual or the help system.
Figure 3-2: Rear panel view (example)
3.2.1
AC Power Supply Connector
Further information:
●
Chapter 4.1, "Connecting to the AC Power Supply"
●
Chapter 5, "Switching On or Off the Instrument"
●
Chapter 9.2, "Replacing the Fuses"
3.2.2
LAN Interface
The 1
gigabit LAN interface (1000 Base
‑
T) can be used to connect the R&S
DVMS to a
local network for remote control, printouts and data transfer. The assignment of the
RJ45 connector supports twisted-pair category 7 STP cables in a star configuration
(STP for shielded twisted pair).
Two LEDs indicate the status of the LAN connection.
●
Green LED
–
LED off: No connection
–
LED on (steady): Connection is established.
–
LED blinking: Connection is established, communication line is in a busy state.
●
Yellow LED
–
LED off: Connection speed is 10
Mbit/s or 100
Mbit/s.
Rear Panel
