Preparing for Use
R&S
®
FSWP
20
Getting Started 1177.5756.02 ─ 13
3. Grab the handles and push the R&S
FSWP onto the shelf until the rack brack-
ets fit closely to the rack.
4. Tighten all screws in the rack brackets with a tightening torque of 1.2
Nm to
secure the R&S
FSWP in the rack.
To unmount the R&S
FSWP from a rack
1. Loosen the screws at the rack brackets.
2. Remove the R&S
FSWP from the rack.
3. If placing the R&S
FSWP on a bench top again, unmount the adapter kit from
the R&S
FSWP. Follow the instructions provided with the adapter kit.
3.5
Connecting the AC Power
In the standard version, the R&S
FSWP is equipped with an AC power supply
connector.
The R&S
FSWP can be used with different AC power voltages and adapts itself
automatically to it. Refer to the datasheet for the requirements of voltage and fre-
quency.
For safety information, see
To connect the AC power
1. Plug the AC power cable into the AC power connector on the rear panel of the
instrument. Only use the AC power cable delivered with the R&S
FSWP.
2. Plug the AC power cable into a power outlet with ground contact.
The required ratings are listed next to the AC power connector and in the data
sheet.
For details on the connector, refer to
Chapter 4.2.2, "AC Power Supply Connec-
Connecting the AC Power
