Functional description of PRxx1 series controllers Rev.H.doc
2016-10-28
26/43
[68]
Set LIGHT
When the input line is activated then
LIGHT
flag is switched
on and respective Timer counts down (see 2.7.9 System
[69]
Clear LIGHT
When the input line is activated then
LIGHT
flag is switched
off and respective Timer is cleared (see 2.7.9 System Flags)
[70]
Toggle LIGHT
The input line is used for switching
LIGHT
flag to opposite
state i.e. ON/OFF (see 2.7.9 System Flags)
[71]
Set AUX1
When the input line is activated then
AUX
1 flag is switched on
and respective Timer counts down (see 2.7.9 System Flags)
[72]
Clear AUX1
When the input line is activated then
AUX
1 flag is switched off
and respective Timer is cleared (see 2.7.9 System Flags)
[73]
Toggle AUX1
The input line is used for switching
AUX
1 flag to opposite
state i.e. ON/OFF (see 2.7.9 System Flags)
[74]
Set AUX2
When the input line is activated then
AUX
2 flag is switched on
and respective Timer counts down (see 2.7.9 System Flags)
[75]
Clear AUX2
When the input line is activated then
AUX
2 flag is switched off
and respective Timer is cleared (see 2.7.9 System Flags)
[76]
Toggle AUX2
The input line is used for switching
AUX
2 flag to opposite
state i.e. ON/OFF (see 2.7.9 System Flags)
[78]
Disarmed mode
(momentary)
When the input line is activated then the controller is
switched to Disarmed Mode (see 2.6 Armed and Disarmed
Modes)
[79]
Armed mode
(momentary)
When the input line is activated then the controller is
switched to Armed Mode (see 2.6 Armed and Disarmed
Modes)
[80]
Card or PIN mode
The input line is used for setting Identification Mode (see 2.4
Identification Modes) into Card or Pin
[81]
Card only mode
The input line is used for setting Identification Mode (see 2.4
Identification Modes) into Only Card
[82]
PIN only mode
The input line is used for setting Identification Mode (see 2.4
Identification Modes) into Only PIN
[83]
Card and PIN mode
The input line is used for setting Identification Mode (see 2.4
Identification Modes) into Card and PIN
Note: You can assign only one input line to the following functions:
[01] Door contact, [03]
Disarmed mode (toggle), [05] AC lost
or
[06] Low battery.
Once the given line is
programmed to one of mentioned functions, then no other input line can be programmed to that
particular function.
2.9 Outputs
All controllers of PRxx1 series (except for PR411DR) have one relay output (REL1) and two
transistor outputs IO1 and IO2. The PR411DR has additional relay output (REL2). As an option two
additional output lines can be provided by connection of XM-2 extension module. When not
triggered the IO1 and IO2 outputs represent high impedances and when triggered they short to the
ground. Moreover, when controller doesn’t work with external reader nor XM-2 extension module
then its CLK and DTA lines can be used as standard outputs. All output lines can be programmed to
following functions:
