Roger PR311SE, Function Manual

Page: 27 / 43

Functional description of PRxx1 series controllers Rev.H.doc 2016-10-28
27/43
Note: PR411DR controller has additional relay output (REL2) which can be programmed in the
same way as any other controller output.
Table 10: Output functions
Code Name Function
[00] Disarmed mode
The output line is inactive when the controller is in Armed
Mode and active when the controller is in Disarmed Mode
(see 2.6 Armed and Disarmed Modes)
[01] Prealarm
The output is used for signaling
PREALARM
(see 2.7.10 Door
Alarm)
[02] Door Ajar
The output is used for signaling
DOOR AJAR
(see 2.7.10 Door
Alarm)
[03]
Pr Door
Ajar The output is used for signaling
PREALARM
+
DOOR AJAR
(see
2.7.10 Door Alarm)
[04] Forced Entry
The output is used for signaling
FORCED ENTRY
(see 2.7.10
Door Alarm)
[05]
Pr Forced
Entry The output is used for signaling
PREALARM
+
FORCED ENTRY
(see
2.7.10 Door Alarm)
[06]
Door Ajar + Forced
Entry The output is used for signaling
DOOR AJAR
+
FORCED ENTRY
(see 2.7.10 Door Alarm)
[07]
PrDoor
Ajar + Forced Entry The output is used for signaling
PREALARM
+
DOOR AJAR
+
FORCED ENTRY
(see 2.7.10 Door Alarm)
[09] Access granted
The output line is activated whenever the controller grants
the access. The time can be set by means of Door Unlock
Time parameter
[10] Door status
The output line is activated when the door is opened and
remains active as long as the door is opened. The output line
practically transmits signals from door contact i.e. from
[01]
Door contact input line
[11] Access denied
The output line is activated for 2 seconds every time the
controller denies the access
[14]
User logged on
term. ID0
Once the user has been identified at terminal ID0 this output
switches to active state and remains active until identification
at terminal ID1. This function may be used for control of
tripod or two way passage (where it shows direction of
passage)
[15] Door bell
The output line is activated for 2 sec. when door bell is
triggered. Door bell can be triggered by means of Function
Key or Input line
[18] Normal door mode
The output line is active as long as the controller operates in
Normal Door Mode (see 2.5 Door Modes)
[19] Unlocked door mode
The output line is active as long as the controller operates in
Unlocked Door Mode (see 2.5 Door Modes)
[20]
Cond. Unlocked door
mode The output line is active as long as the controller operates in
Cond. Unlocked Door Mode (see 2.5 Door Modes)