Rockwell Automation Reliance electric 6SP201-015, User Manual

Page: 33 / 300

About the Drive
2-19
Low Voltage Directive (73/23/EEC)
•
EN50178 Electronic equipment for use in power installations
EMC Directive (89/336/EEC)
•
EN61800-3 (Second Environment) Adjustable speed electrical
power drive systems Part 3: EMC product standard including
specific test methods
General Notes
To be CE-compliant, the motor cable should be kept as short as
possible in order to avoid electromagnetic emission as well as
capacitive currents.
AC drives may cause radio interference. The user is required to take
measures to prevent interference in addition to the essential
requirements for CE compliance listed in section 2.6.1, if necessary.
If the adhesive label is removed from the top of the drive, the drive
must be mounted in a cabinet with side openings less than 12.5 mm
(0.5 in) and top openings less than 1.0 mm (0.04 in) to maintain
compliance with the Low Voltage Directive.
Conformity with CE EMC requirements does not guarantee that the
entire machine or installation will comply with the requirements.
Many factors can influence total machine/installation compliance.
Use of line filters in ungrounded systems is not recommended.
SP600 drives can generate conducted low frequency disturbances
(harmonic emissions) on the AC supply system.
2.5.1 Essential Requirements for CE Compliance
All conditions listed below must be satisfied for SP600 drives to
meet the requirements of EN61800-3 for the Second Environment
(Industrial).
•
Standard SP600 CE-compatible drive.
•
Grounding as described in section 5.2 of this manual.
•
Output power, control (I/O) and signal wiring must be braided,
shielded cable with a coverage of 75% or better, metal conduit or
equivalent attenuation.
•
All shielded cables should terminate with the proper shielded
connector.
•
Conditions in table 2.6.