Specifications and Site Requirements
Electrical Specifications
68
MagneMotion
Rockwell Automation Publication MMI-UM013B-EN-P - April 2020
NC-E Node Controller
6–36V DC, 40 W max based on configuration and operating mode. See
for the mechanical drawing.
DC Power Option
DC power from a user-supplied power supply requires 6–36V DC, 40 W.
The actual power being drawn depends on the operations being performed. Make sure that all
power wiring can carry the full load and has a limited power source or the power source is
fused to the maximum rating of the wiring.
Figure 4-12: NC-E Node Controller Electrical Connections, Controls, and Indicators
NOTICE
Any user-supplied power supply must be NRTL/ATL approved.
NOTICE
The NC-E node controller does not support Power over Ethernet. Never con-
nect these node controllers to a powered network as damage to internal com-
ponents can result.
NOTICE
Connecting to the DC power connector on the NC-E node controller must be
done with the power supply off. Connecting with the power supply on can
cause a short circuit at the connector, which can damage the power supply or
any other equipment being powered by that power supply.
Ethernet
Digital I/O
Power
Console Port
Status Indicators
USB
Power
Reset
