Maintenance
Repair
MagneMover LITE Service Manual
105
Rockwell Automation Publication MMI-UM037A-EN-P - April 2020
Figure 37: Precision Rail Vehicle to Rail Orientation
Removing Vehicles by Removing Rails
The single or dual array vehicles can be removed from the precision rail system by removing
a precision rail section.
1.
Stop all motion on the path where the vehicle is being removed.
2.
Remove a small section of the precision rail by removing the M5 screws that secure it
to the spine plates.
3.
Move the vehicle to be removed to the open section and lift it out.
NOTE:
Once vehicles are removed from the transport system, they must be stored in
their original packaging to help protect the vehicle and to minimize any
safety risks.
4.
Replace the removed rail section.
A.
Position the rail over the edge of the spine plates. Align the letters that are
engraved on the end of each rail segment and the mounting holes in the rail
over the spine plate holes.
B.
Secure the rail to the corresponding spine plates using M5 SHC screws, tighten
each screw to 1.8 N•m [16 in•lb], follow the sequence that is shown in the
MagneMover LITE User Manual.
5.
Return the MM LITE transport system to normal operation.
Concentric
Motor Side
Eccentric
Stand Side
of Rail
Bearings
Eccentric
Bearings
Bearings
Concentric
Bearings
of Rail
Single Array Vehicle
Dual Array Vehicle
