Rockwell Automation 700-1308-00, Service Manual

Page: 100 / 138

Maintenance
Repair
100 MagneMotion
Rockwell Automation Publication MMI-UM037A-EN-P - April 2020
4. Apply two to three drops of Loctite 243 to the threads at the top center of each puck as
shown in
Figure 33 .
5. Position the large thrust washers on the tops of both pucks.
6. Position the linkage plate assembly over the tops of both pucks and make sure it seats
on the thrust washers.
7. Insert the flange bearing, washer gasket, and washer in each of the mounting holes on
the top of the linkage plate.
8. Secure the linkage plate to the top of the pucks using new M6 screws. Tighten each
screw to 2.8 N•m [25 in•lb].
The Loctite must cure for 2 hours at 22° C [72° F] before using the puck.
Figure 33: Attach Tandem Wheeled Puck Linkage Plate Assembly
9. Remove the Tandem Wheeled Puck Assembly from the fixture and reinstall on the
MM LITE transport system (see
Replace Pucks on page 78 ).
If the tandem puck is not being reinstalled on the transport system, store it in its origi-
nal packaging, or wrap it in bubble-wrap, for protection.
Linkage Plate
Installation
Fixture
Puck
Puck
M6 Shoulder Screw
(2X)
Thrust Washer
Thrust Washer
Flange Bearing
Washer Gasket
(2X)
(2X)
(2X)
(2X)