RK3288 Hardware Design Guide
Fig 13-2
Recommendations for DVP SOC Camera Sensor usage:
Suggest to connect Sensor output YUV data bit0-bit7 to RK3288 DVP interface
bit0-bit7;
If front and back cameras are not requested to be working at the same time, suggest
to use RAW Sensor output mode.
If front and back cameras are requested to be working at the same time, since
RK3288 has only one CUP with ISP, only one of two DVP SOC Sensor can be RAW
Sensor, another one must be MIPI Sensor;
RK3288 supports dual MIPI Sensor input, recommendations for MIPI Camera Sensor as
below:
First use MIPI_TX_RX
(
MIPI PHY1
)
to connect MIPI Camera module;
If Dual MIPI LCM is in use, connect MIPI_RX
(
MIPI PHY0
)
to MIPI Camera module;
Sensor MIPI Lane amount ≥ MIPI Lane amount supported by PHY, all MIPI meet this
condition can be connected to corresponding PHY, but Lane amount should be based
on PHY in actual;
Fig 13-3
Summary of Contents for RK32 Series
