3. DESCRIPTION OF EACH MODULES
IMSRM02-E6
31
3.3.4 Settings before operation
Communication setting directions
Using the dip switches inside the PCP module, sets the communication speed and data bit
configuration.
1.
To separate the module mainframe from the mother block, press the bottom on the module,
lifting upward, to release connection.
2.
Data configuration and communication speed can be set with the dip switches located in the PCP
module.
Top section
OFF
ON
4 3 2
1
Rear view of module mainframe with mother block removed
1
2
Data bit configuration
3
4
Communication speed
OFF
OFF
8-bit without parity *
OFF
OFF
2400 bps
OFF
ON
7-bit even parity
OFF
ON
4800 bps
ON
OFF
7-bit odd parity
ON
OFF
9600 bps *
ON
ON
Do not set this one
ON
ON
19200 bps
* Factory set value
* Factory set value
3.
After communication setting is complete, place the module mainframe opening on top of the
mother block tab and snap the lower part of module mainframe on to the mother block. A
snapping sound will be heard when module mainframe is securely connected to mother block.
Mother block
Module mainframe
Upper
section
Mother block
Module mainframe
Lower
section
Press bottom of module
and lift upward to release
