RiTTO TWINBUS, System Manual

Page: 105 / 197

Installation: Assembly, connection and start-up
105
In
st
al
la
tio
n
1) The switching time can be set for operating modes 3, 4, 5, 6, 8 and 9. It can be selected from 1 s to 127.5 min
(short time: 1 s to 127 s, long time: 30 s to 127,5 min).
2) The yellow LED flashes every second. In operating modes 3 and 4, the switching time is increased by one second
every time the LED flashes. In operating modes 5,68 and 9, the switching time is increased by 30 seconds every
time the LED flashes. Pressing the "Z" button will overwrite the old time setting.
If the time limit has been exceeded:
Repeat the procedure.
If the programming procedure failed:
Check at the TwinBus power supply unit whether the adjustment protection has been enabled.
If 10 bell buttons have already been programmed, the memory of the device is full. If necessary, delete all settings
and reprogram all required switching commands.
3) A maximum of 10 switching commands can be set.
A switching command is triggered by a TwinBus unit (e. g. switch light on with light button , control button ,
internal call button or secret number from coding module).
Function Activity Result
Function Activity Result
Program switching command
3)
✔
Short tone: Device is ready for operation.
/
No tone: Time limit exceeded.
/
Long tone: Programming procedure failed.
Open plexiglass cover
on switching device
1)
Set switching
time
'&
% $ $ # " "
!
'&
%
$ $ #
" " !
set position to "0"
'&
% $ $ # " "
!
Press and hold "Z"
until
'&
% $ $ # " "
!
LED
flashes
2)
set to position of desired
operating mode
0
98
7 6 5 4 4
32
1
0
98
7
6 6 5 4 4
3
21
3, 4,
5, 6,
8, 9
0
98
7 6 6 5 4 4
32
1
0
7
6 6 5 4 4
32
98
2, 3,
4, 5,
6, 8,
9
set to position of desired
operating mode
'&
% $ $ # " "
!
Press and hold "P" for 5
s until
'&
% $ $ # " "
!
LED flashes
Within one minute,
transmit switching
command
'&
% $ $ # " "
!
LED goes out,
acoustic signal at door
station
RiTTO