Rinnai aiM 115, User And Installation Manual

Page: 25 / 66

21
For special maintenance needs, to facilitate the intervention of
the RINNAI authorised services, the boiler can be temporarily
transferred to a different place than the one in which it is
installed.
Only the Technical Assistance Centers have the authorization
and the capacity to disassemble the exchanger and / or
replacement of the thermal fuse.
ATTENTION : Any unauthorized intervention does void the
warranty.
Fig. A: aiM 65 Thermal fuse Fig.B: aiM 85/115/150 Thermal fuse
Thermal fuse
Activation temperature 3
Requirements and conditions
Messa in opera
Technical room and ventilation
It is recommended to install Rinnai aiM heat generators in a
frost-free room and do not store material or flammable liquids
in the technical room where the heat generator.
For the realization of the technical rooms inside the buildings
where to install the heat generators, the must be respected
the Ministerial Decree of 12 April 1996 and any further
prescriptions of the Fire Brigade
The installation room must be equipped with one or more
permanent ventilation openings on external walls.
It is also necessary to make sure that the air for combustion
there are no high concentrations of dust or chemicals
elements that could damage the exchange thermal surface.
The chemical components that could potentially become
aggressive where dissolved in the air and can be paints,
solvents, detergents or aerosols.
The place of installation of the generator and its accessories
must have suitable technical and structural characteristics so
that it is possible to carry out, in conditions of safety and ease,
the operations of:
•
installation (according to the indications of the ltechnical
legislation and technical regulations);
•
maintenance;
•
removal and possible replacement of the device and / or
individual components.
These boilers must be used for the room heating and similar
and are used to heat water at a temperature below boiling
point at atmospheric pressure; they must, therefore, be
connected to a heating system suitable for them performance
and their power.
Rinnai aiM boilers can be installed only inside and are
intended exclusively for plants thermal. If outdoor installation
is planned, it must be an appropriate protection structure
from agents is provided atmospheric, which could be harmful.
It is essential to provide for proper access to the elements
of safety and control and the equipment for operations of
maintenance.
It is essential to provide for proper access to the elements
of safety and control and the equipment for operations of
maintenance.
The installation of appliances powered with density gas
greater than 0.8 bar (eg LPG) is allowed exclusively in above
ground rooms, possibly communicating with rooms that are
also above ground. In both in cases, the walking surface must
not have hollows or depressions such as to create pockets of
gas that cause dangerous conditions. conditions.
General safety warningst