RIGOL
Copyright 2004 Rigol Electronic
1-7
CAUTION:
To avoid damage the instrument, always ensure the input
voltage at BNC does not exceed the maximum voltage (400Vpp when 1M
Ω
input impedance is selected, or 5Vrms when 50
Ω
input impedance is
selected.)
!
Probe comp
Figure 1-6
②
Set the probe attenuation to 10X. To do this, push CH1
→
Probe
→
10X.
Figure 1-7
Probe attenuation
③
Push the AUTO button. Within a few seconds, you could see a square wave in
the display (approximately 3 V at 1 kHz peak- to- peak).
④
Push the OFF button to turn off channel 1, push the CH 2 button to turn on
channel 2, repeat steps 2 and 3.
User Manual for DS5000 Series