RIGOL
Chapter 4 :Prompt messages & troubleshooting
Prompting messages
Dot display only:
Prompts that you could only use Dots type for display under this
setting.
Function not available:
Prompts that this function is not available under current
setting.
Measurement already selected:
Prompts that the measurement parameter you
pressed is already displayed on screen.
Memory position at limit:
Prompts that the Memo Offset is at the full range of the
memory.
No active cursor:
Prompts that you haven’t set the cursor source while using the
Track cursor measurements.
No signal found:
Prompts that there is no signal connected to the instrument, or
the signal is out of the AUTO range for detecting while pressing the AUTO button.
No zoom at this Time/Div:
Prompts that under some time bases or X-Y mode,
the Delayed Scan function is not available.
Position at limit:
Prompts that the channel offset is at limit while turning the
vertical POSITION knob to adjust the vertical position of the channel.
Real Time Div at limit:
Prompts that the time base is up to the highest horizontal
resolution under the Real-Time sampling mode.
Sampling at limit:
Prompts that the sampling rate is at limit under the X-Y mode.
Save finished:
Prompts that the storage progress finished.
Time/Div at limit:
Prompts that the Time/Div is at limit while turning the
horizontal SCALE knob to adjust time base.
The storage is empty:
Prompts that current position of the memory is empty for
waveforms or settings saved.
Copyright 2004 Rigol Electronic
4-1
User Manual for DS5000 Series