25
ENGLISH
5100
RPM
RANGE RATED
- Once the required output has been set (maximum heating), indicate the
value on the self-adhesive label supplied. For subsequent controls and
adjustments, refer to the set value.
b
The calibration does not entail the ignition of the boiler.
The boiler is delivered with the adjustments shown in the technical data table.
Depending on plant engineering requirements or regional fl ue gas emission
limits it is, however, possible to modify this value, referring to the graphs
below.
800
1200
1600
2000
2400
2800
3200
3600
4000
4400
4800
5200
5600
6000
6400
6800
7200
7600
8000
2
4
6
8
10
12
14
16
18
20
22
24
26
28
30
Portata termica (kW)
Giri v
en
tila
tor
e (r
.p
.m.)
Heat input - boiler fan rpm curve
Family 25 KIS
800
1200
1600
2000
2400
2800
3200
3600
4000
4400
4800
5200
5600
6000
6400
6800
7200
7600
2
4
6
8
10 12 14 16 18 20 22 24 26 28 30 32
y
Portata termica (kW)
Giri v
en
tila
tor
e (r
.p
.m.)
800
1200
1600
2000
2400
2800
3200
3600
4000
4400
4800
5200
5600
6000
6400
6800
7200
7600
8000
8400
2
4
6
8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38
Portata termica (kW)
Giri v
en
tila
tor
e (r
.p
.m.)
5.15 Lights and faults
If any faults should occur, a screen will appear on the display indicating
the relative error code and a brief alphanumeric description of the same.
Pressing the “
BACK
” key it is possible to return to the main screen,
where the presence of the fault is indicated by the
flashing icon.
1.3
bar
42
°C
MENU
STATE
SET
INFO
PLANT
HOT WATER TEMPERATURE
FRI
18/05/2013
12:17
It is possible to return to faults description page highlighting the icon with
the “
UP
” and “
DOWN
” keys and then pressing “
ENTER
”.
The faults description screen is automatically displayed once the display
illumination time has elapsed without any button being pressed.
Press the “
UP
” and “
DOWN
” keys to display the description of any other
faults present.
Reset function
In order to reset the boiler's operation in the event of a fault, it is necessary
to access the fault description screen. If the lockout is of a non-volatile type
that requires a reset procedure, this will be indicated on the screen, and can
be performed by pressing the "
OK
" button on the REC10.
At this point, if the correct operating conditions have been restored, the
boiler will restart automatically.
There are a maximum of 3 consecutive attempts at a release by the
REC10, when used up it is possible to unlock the boiler by cutting off and
reconnecting the electrical supply.
E020
RESET ATT. EXHAUSTED
LIMIT THERMOSTAT
b
If the reset attempts do not activate the boiler, contact the Technical
Assistance Centre.
Heat input - boiler fan rpm curve
Family 30 KIS
Heat input - boiler fan rpm curve
Family 35 KIS
Fan rotations (r
.p.m.)
Fan rotations (r
.p.m.)
Heat output (kW)
Heat output (kW)
Fan rotations (r
.p.m.)
Heat output (kW)
