29
ENGLISH
- select SYSTEM RESET with the "
UP
" and "
DOWN
" keys , confirming
the selection
ZONES MANAGER
SENSOR CALIBRATION
INSTALLATION
SYSTEM RESET
INSTALLER
Ø
- select CONFIRM to conform the system reset or else CANCEL to cancel
the operation.
CANCEL
CONFIRM
Note:
After a reset it is necessary to carry out a new configuration of the
system; for details about this procedure, see the following section.
5.20 System confi guration
b
This operation must be carried out only by professionally qualifi ed
personnel.
When restarting after a replacement of the REC10 rather than after a
“SYSTEM RESET”, the remote control an initial screen with the firmware
revision. Pressing “
ENTER
” starts a guided procedure for configuring
the system; select the desired options with the “
UP
” and “
DOWN
” keys,
confirming the selection:
PRESS ANY KEY TO
CONTINUE
REC10R
R02.06
Welcome at home
- LANGUAGE selection:
ENGLISH
ENGLISH
ROMANESC
ENGLISH
ITALIANO
- setting TIME and DATE
ENTER TIME AND DATE
TIME & DATE
12
17
18/11/2013
:
- setting the operating mode of the REC10:
MASTER
: select this option when the REC10 is also a MACHINE
INTERFACE.
- configuration selection:
DA AKM
: to reset the current boiler configuration on REC10 MASTER
and finish the operation
NEW
: to set a new system configuration restoring the factory setting of
the parameters
NEW
FROM AKM
SELECT THE TYPE OF
CONFIGURATION
- Whenever a “NEW” configuration is selected, proceed as follows
- select REC10 functionality:
MACHINE
: if the REC10 is used only as a system interface and not as
an ambient regulator
AMBIENT
: if the REC10 is used as a system interface and also as an
ambient regulator of the zone where it is installed
