Page 47 of 88
RN.302.LO Common Front Panel Facilities
The Status Indicators of the RN.302.LO and the connectors of the Network and Control Section are
the same as on any other 19” RockNet device. For detailed description please see the generic part of
this manual.
RN.302.LO Common Configuration
The RN.302.LO provides the complet e configuration capabilities that are accessible via the front panel
operation. The operation is described in the respective generic chapters of this manual.
•
Default Mode
- Assignment of Add Quads (left -hand and right-hand Quad)
- Assignment of Device ID
•
Options Mode
- Set Sync Master
- (Set External Sync)
- Lock Front Panel
- Display Temperature
- 80 Ch mode (if Master)
- Switch Display
•
Channel Mode (is described in this chapter in detail)
- Set MUTE
- Adjust CLIP LEVEL
RN.302.LO Output Section Details
The RN.302.LO provides 8 analog line level output channels on XLR connectors.
The picture below shows two of these channels. The left one belongs to the left-hand Quad and the
right one belongs to the right-hand Quad. The separation line (9) and the two yellow arrows (9a) and
(9b) indicate the Quad correlation. The designation point (8) can be used for individual channel labels.
1
XLR OUTPUT Connector
2
MUTE Indicator
3
SIGNAL P RESENT Indicat or
4
CLIP Indicator
5
OPEN Indicator
6
Channel SELECT button
7
CHANNEL OP EN Activator switch
8
DESIGNATION Point
9
Quad separation line
9a
Right-hand Quad channels
9b
Left-hand Quad channels
RN.302.LO output section
RN.302.LO Channel LED Description
MUTE
Mute
Indicator LED
Red
on = channel muted
SIG
Signal Indicator LED
Green
Lights up if signal is present (0dBFS)
CLIP
Clip
Indicator LED
Red
Lights up if signal clips (-48dBFS )
OPEN
Open Indicator LED
Yellow
on = output circuitry is prepared for redundancy *)
*) please see Output Redundancy in this chapter
USO
RESTRITO
