Page 15 of 88
RN.300 Common Controls and Displays
RN.300 Control Section
RockNet 19” RN.300 I/O devices are equipped with a common local c onfiguration interface which is
intuitive and easy to use.
The c ontrol section provides the controls to set up and configure the devic e and network without a
computer and provides LEDs to indicat e the status of the device and the net work.
The local configuration menus of RockNet have common and specific parts.
The cont rol Section incorporates the displays and push buttons described below that are used for
intuitive operation of a t hree level menu. For more detailed information please refer to pages 18 to 20
of this manual.
•
Default mode,
permanently active
displays:
- Quad routing information of the two or four Quads of the device
- Device ID number
•
Channel mode,
momentary active (push SEL button)
displays:
- Channel parameters of the respective device:
RN.301.MI:
MUTE
GAIN
PHANTOM
RN.302.LO: MUTE
- -
CLIP LEVEL
RN.331. DD: MUTE
- -
- -
RN.332. DO: MUTE
- -
- -
RN.333. DI:
MUTE
- -
- -
•
Options mode,
momentary active (push 4&5 and 8&9 simultaneously)
- general device and net work settings:
Set Sync Master & select external sync source
Lock front panel operation
Display device temperature
Switch display off
RN.300 Di splay and Push Button Details
The displays and push buttons are structured the same way for each device:
RN.300 Generic Control Section
1
Left-hand di splay
2
Middle display
3
Right-hand display
4 & 5
Push buttons to
- set left-hand Quad no.
- set channel parameter
- access & change OP TIONS menu
6 & 7
Push buttons to
- set right-hand Quad no.
- set channel parameters
8 & 9
Push buttons to
- set device ID
- set channel parameters
- access & change OP TIONS menu
USO
RESTRITO
