Ricoma Quick Start Guide
22
3. Line up the holes in the inner peg with the holes in the outer
peg in order to re-insert the black knobs. See Figure 44.
4. Secure the positioning of the pegs by rotating the knobs
clockwise. Note: You may position the pegs lower to use your
table as a workbench. However, in order to use the sash frame,
you will need to position the pegs at their highest point.
5. Loosen the hex screw on the middle metal bracket underneath
the table in order to slide the table onto the machine’s lip. See
Figure 45.
6. Place the left table above the pegs, making sure the lip behind
the sewing arm slides in between the metal clips underneath
the table. Use the openings as a guide to help you see where
to position the table. See Figure 46.
7. Underneath the center of the table, you will find a slot for the 5
mm Phillip screw included in your toolkit. Insert the screw into
the slot and the pegs, and fasten the screw to attach the table
to the pegs. See Figure 47.
8. Using your hand, fasten the hex screw on the top center metal
clip underneath the table to stabilize the table. You can lock
these in with your Allen wrench after you have placed all the
tables on. See Figure 48.
9. Place all the remaining tables above the pegs, making sure
the lip behind the sewing arm slides in between the metal
clips underneath the tables.
10. Repeat steps 7 & 8 for all remaining tables.
11. Secure all screws tightly to keep the table stable during the
embroidery process.
Figure 44
Figure 45
Figure 46
Figure 47
Figure 48
