Ricoma Quick Start Guide
18
Figure 36 - Cap Ring
To do so, loosen the screw on the bottom right of the cap
ring using a Phillip screwdriver. Tighten the screw once
you have reached the desired position for the band.
How to remove the cap driver
How to install the cap driver
1. 1. Using the 4 mm Allen wrench included in your toolkit, loosen the hex screws that connect the
cap driver to the pantograph.
2. To remove the cap driver, carefully pull the cap driver toward you using both hands. Keep in mind:
It’s not necessary to completely remove the screws. It should be able to slide off easily if you
have loosened both hex screws.
3. Repeat this process with the remaining heads.
1. First, select the cap hoop on your control panel. You will find the preset hoop function under the
Design Settings menu. Once you have selected the preset cap hoop, the pantograph will move
forward.
2. If you haven’t done so already, make sure the flat support bracket is removed. To remove the
bracket, loosen the hex screws that attach the bracket to the pantograph rail.
3.
Insert the cap driver on the machine, making sure the
sewing arm goes through the opening in the back of the cap
driver. Each cap driver and cap ring is numbered. Use the cap
driver labeled “1” for head 1. Use the cap driver labeled “2” for
head 2, and so on.
4.
The cap driver is equipped with four small wheels that
slide onto the rail underneath the sewing arm of the machine.
Position the cap driver in line with the railing, making sure all the
wheels are aligned. See Figure 37.
Figure 37
