Ricoma Quick Start Guide
47
The machine needs to be aligned to 100 degrees in order to operate
properly. A main axis error means the main axis is not lined up to 100
degrees, which is the proper position for the machine to start and stop
sewing.
This error can be caused if a needle hits the hoop, if you get a bird’s nest,
and other reasons. If you get this error, clear the message by pressing
OK.
To correct this error, you can use the 100 degree key on your panel, which automates the process of
Figure 114
Emergency stop message
An emergency stop error occurs when the emergency stop switch
has been pushed during shipping or under an emergency situation.
If you receive an emergency stop error, you can easily get rid of it
by rotating the emergency stop button clockwise, following the
directional arrows on the button. See Figure 114.
Note:
Be sure to not pull this switch up. It will pop out by itself once rotated. Pulling on it could damage
the switch.
If necessary, back up your machine to ensure there are no missed stitches.
A no needle/color change error occurs when the machine cannot
detect which needle is over the needle plate. This may happen
because the machine head is positioned between two needle plates.
If you receive a needle error on your panel, you may see a question
mark or a 0 appear on your needle icon where the needle number
was once displayed. If so, clear the message and locate the color
change motor shaft behind the control panel. Using an open-ended
adjustable wrench, rotate the shaft slowly until the machine reaches
a needle number. The color change box will light up on the needle the
machine is aligned to. See Figure 115.
Figure 115
No needle error/color change error
Figure 116
Motor fault error/Main axis error
