Ricoh M080, Service Manual

Page: 99 / 294

Error Messages
SM 6-3 M080
T
rouble
shooting
1st/2nd Message Problem/Solution
Cannot print.
Check the file you want to print is a supported file
type. Check for misfeeds and ask your network
administrator for help.
Check network Settings.
(103/203)
The IP address setting is incorrect. Check the IP
address, subnet mask, and gateway address.
Classification Code Error
A classification code is not specified for the print job.
Enter a classification code using the printer
properties and print the document again.
Connect failed:WirelessCard
Turn power off, check card.
Check there is a Wireless LAN board installed.
Check that it is a supported board. If it is, check it is
installed correctly.
Install the correct board properly.
Cover Open. Please close the
indicated cover.
Close the cover indicated on the control panel.
Duplex mode is in off position for
(tray name)
The duplex mode for the indicated tray is off; you can
only use one-sided printing. Press [Change] to
change the tray's settings, press [JobReset] to reset
the job, or press [Form Feed] to force printing.
Ethernet Board Error
An error on the Ethernet board is detected. Pull out
and then re-install the controller board. If the problem
persists, contact your sales or service representative.
Exceeded max. print size. Press
[FormFeed] or [JobReset].
The specified paper size exceeds the maximum size
supported by this printer. Press [Form Feed] to force
printing or [JobReset] to cancel printing.
Exceeded max. print size. Press
[JobReset].
The specified paper size exceeds the maximum size
supported by this printer. Press [JobReset] to cancel
printing.
Failed to connect to server for
Remote Diagnostics.
The printer cannot communicate with Remote
Communication Gate. Check the connection to the
Remote Server Gate.