Ricoh M080, Service Manual

Page: 100 / 294

Error Messages
M080 6-4 SM
1st/2nd Message Problem/Solution
Independent-supply toner
Independent-supply toner is set. Use toner
recommended for this printer.
IPDS font error. Turn power
switch off then on. Select Reset
IPDS Fonts in Maintenance.
IPDS font error has occurred. Perform the shutdown
procedure, and then turn off the power of the printer.
Turn on the power again, and then execute [Reset
IPDS Fonts].
IPv6 Address already exists
Link-local Address(109/209)
The same IPv6 address already exists. Consult your
network administrator.
IPv6 Address already exists
Stateless Address(109/209)
The same IPv6 address already exists. Consult your
network administrator.
IPv6 Address already exists
Manual Config.
Address(109/209)
The same IPv6 address already exists. Consult your
network administrator.
Load paper in (tray name) or
[Cancel] to FormFeed.
There is no paper in the specified tray. Load the
specified paper in the tray, press [JobReset] to reset
the job.
Option RAM Error
The printer cannot detect an optional SDRAM
module. It may be incorrectly installed.
Check if it is installed properly.
Output tray is full. The output trays are full. Remove the paper.
Parallel I/F Error
The printer's self diagnostic test failed due to a
loopback error. Replace the IEEE 1284 board that
caused the error.
Prepare Replacement Check
print cartridge replacement(s).
The toner has run out, or the photo conductor unit
has reached the end of its service life. Prepare a new
print cartridge.
Printer Font Error.
There are problems with the printer's font file.
Contact your sales or service representative.