Ricoh HL-F1, Field Service Manual

Page: 175 / 296

• Selector 2: Use of non-standard commands
If this selector is set to "0," the machine can use non-standard commands (the machine's native-mode
commands, e.g., NSF, NSC, and NSS) for communications. If it is set to "1," the machine will use
standard commands only.
• Selectors 3 and 4: No. of retries
These selectors set the number of retries in each specified modem transmission speed.
• Selector 5: T5 timer
This selector sets the time length for the T5 timer.
• Selector 6: T1 timer
This selector sets the time length for the T1 timer.
• Selectors 7 and 8: Timeout for response from the called station in automatic sending mode
If the machine (calling station) receives no response (no G3 command) from the called terminal in
automatic sending mode for the period specified by these selectors, it disconnects the line.
WSW10 (Protocol definition 2)
Selector No. Function Setting and Specifications
1 Not used. -
2
Time length from transmission of the last
dial digit to CML ON
0: 100 ms 1: 50 ms
3
Time length from CML ON to CNG
transmission
0: 2 sec. 1: 4 sec.
4
Time length from CML ON to CED
transmission (except for facsimile-to-
telephone
switching)
0: 0.5 sec. 1: 2 sec.
5
6
No. of training retries
No. 5 6
0 0 : 1 time
0 1 : 2 times
1 0 : 3 times
1 1 : 4 times
7 Encoding system (Compression): MR 0: Allowed 1: Not allowed
8 Encoding system (Compression): MMR 0: Allowed 1: Not allowed
Firmware Switches (WSW)
173
5