Ricoh G081, Service Manual

Page: 48 / 272

MACHINE INSTALLATION
G081/G092 1-20 SM
6. When using DHCP with TCP/IP protocol, set network boot, as follows.
1) From within Network Setups press the “
!
”
or “
"
” key to display to display “DHCP,” and
then press the Enter key. In about two
seconds, the display returns to the "Network
Setup" setting screen.
NOTE: * shows the current setting.
Depending upon the firmware this setting may be located under
“Network Boot.”
7. When all of the settings are done, press the
On Line key. “Ready” appears on the panel
display.
8.
Print the configuration page to confirm the settings made. See 1.2.6 for printing
the configuration page.
Network Setup:
#
DHCP
G081I922.WMF
Ready
G081I901.WMF