Ricoh G081, Service Manual

Page: 155 / 272

FIRMWARE UPDATE PROCEDURE
SM 5-31 G081/G092
Service
Tables
10. Wait until the message "Updated Power Off
On" is displayed.
11. Turn the main switch off.
12. Remove the PCMCIA memory card.
13. Attach the cover [A] if you have completed the firmware update procedures.
14. Close the front door.
Controller System Firmware
1. Prepare three PCMCIA memory cards that contain the system firmware
(Onboard System 1/2, Onboard System 2/2, Network Support).
2. Turn the main switch off.
3. Remove the cover [A].
4. Insert the PCMCIA memory card [B] that contains "Onboard System 1/2."
5. Open the front cover or right cover.
6. Turn the main switch on.
7. Wait until the message "Onboard Sys. 1/2" is
displayed.
NOTE: 1) If you did not insert the correct PCMCIA memory card, the proper
message is not displayed. In this case, press the up-arrow key
("Exit" is displayed), press the enter key ("Close Front and/or Right
Cover" is displayed), and turn the main switch off. After this, insert
the correct IC card and resume upgrading.
2) If you have not fully inserted the PCMCIA memory card, the
message "Close Front and/or Right Cover" is displayed. In this case,
turn the main switch off, and fully insert the PCMCIA memory card.
When completed, resume upgrading.
8. Press the On Line key. "Verifying Data" is
displayed. Next, "Checking Controller" is
displayed.
Updated
Power Off On
G081S524.WMF
Onboard Sys. 1/2
G081S525.WMF
Verifying Data
G081S526.WMF
Checking
Controller
G081S527.WMF