Ricoh FW870, User Manual

Page: 73 / 206

NOTE: If the fusing temperature is lower than 60 C when the main switch is
turned on, the development motor will rotate. In this case, it is not
necessary to access the SP mode to load the total 2 Kg of developer
(steps 25 to 28).
Turn off the main switch to stop the development motor after the
developer is loaded from the development entrance. Then, pour in
another 1 kg of developer.
24. Press the following keys on the operation panel:
Clear Modes/Stand-by key [A]
+ key [B]
+ key
Clear/Stop key [C]
25. Press the "Clear/Stop" key again for longer than 3 seconds. The wrench
and tone end indicators will blink (SP INPUT/OUTPUT mode).
26. Select 28 using the "+" key and "–" key [D] and press the "#" key [E]. The
development motor will rotate.
27. Press the "#" key to stop the development motor after the developer is
loaded from the development entrance. Pour another kg of developer into
the development unit evenly across its width (Total: 2 kg). Press the Clear
Modes/Stand-by key 3 times to leave the SP mode.
[A]
[E]
[B]
[D]
[C]
A174I521.wmf
COPIER INSTALLATION PROCEDURE (A174) 25 July 1996
3-12