Ricoh FW870, User Manual

Page: 57 / 206

8.5 ENERGY SAVER FUNCTION
When the copier is not in use, the energy saver function reduces the power
consumption by decreasing the fusing temperature.
When the Clear Modes/Stand-by key is hold down for over 2 seconds, the
copier goes into the energy saver mode. A message is displayed on copy
counter and all the other indicators turn off.
The fusing temperature is decreased by 15
°
C from one of the normal mode
settings for copying. The energy saving ratio is approximately 14%. The
waiting time until the copier returns to the ready condition is approximately 60
seconds.
NOTE: The above energy saving ratio is a standard value measured in
laboratory tests under controlled conditions. The actual ratio will vary
depending on environmental conditions, copy modes, power supply
conditions and measurement instruments.
Press the Clear Mode/Standby key. The copier is returned to the ready
condition after a warm-up time.
When the auto energy saver mode (SP#11) is selected, the copier
automatically goes to the energy saver mode at the auto reset time selected
by SP#10.
FUSING AND PAPER EXIT 25 July 1996
2-42