4
4-11
Network Setup
IP Static (Ethernet)
—Click to assign the Fiery 3850C a static IP address, which will
not change.
IP Address (Ethernet)
—Enter the Fiery 3850C IP address for Ethernet. You must
change the default to a valid address for your network. For information about setting
up printing with TCP/IP, see Chapter 5.
Subnet Mask (Ethernet)
—If you need to set the subnet mask, enter one of the
following values:
•
255.0.0.0
if the IP address starts with a number less than 128
•
255.255.0.0
if the IP address starts with a number from 128 through 191
•
255.255.255.0
if the IP address starts with a number greater than 191
N
OTE
:
Be sure to confirm the subnet mask setting with your network administrator
before proceeding. In some cases the required setting may be different from those
listed.
Gateway
If your TCP/IP network has a gateway, and users outside the gateway print to the
Fiery 3850C using TCP/IP, enter the gateway address. Obtain the correct gateway
address from your network administrator.
IP Auto
—Use this option to get the gateway address automatically for printing with
TCP/IP. This option is available only if you selected DHCP or BOOTP as the
protocol.
If you select the DHCP or BOOTP protocol and later change it to RARP, you must
return to Gateway Setup and enter a static Gateway address. You can then set the
address manually. This is because RARP does not support automatic assignment of the
gateway address.
IP Static
—Use this option to set the gateway address for printing with TCP/IP. If your
network uses a gateway, you must change the default to a correct gateway address for
your network.
