3
3-13
Network Setup options
Enable AutoIP
Yes/No [No]
Select Yes to allow the Fiery 3850C to obtain its Ethernet IP address by searching the
network. Depending on your network and the protocol you select in the following
option (DHCP, BOOTP, or RARP), the IP address can change. Select No to assign the
Fiery 3850C a static IP address that will not change. If you select No, you proceed to
the IP Address option, where you manually set the IP address.
Enable DHCP
Yes/No [Yes]
This option appears only if you answered Yes to Enable Auto IP Configuration.
DHCP allows the Fiery 3850C to obtain the Ethernet IP address and Subnet Mask
automatically.
Depending on your network, the Fiery 3850C might be assigned a different address
after you reboot the Fiery 3850C. With the DHCP setting, the Fiery 3850C can be
assigned a different address even if it is not rebooted. Make sure the network is already
configured properly for the protocol you select.
Enable BOOTP
Yes/No [No]
This option appears only if you answered Yes to Enable Auto IP Configuration.
BOOTP allows the Fiery 3850C to obtain the Ethernet IP address and Subnet Mask
automatically.
Enable RARP
Yes/No [No]
This option appears only if you answered Yes to Enable Auto IP Configuration. RARP
only allows the Fiery 3850C to obtain the Ethernet IP address automatically.
Eth. IP Address
[127.0.0.1]
Enter the Fiery 3850C IP address for Ethernet. This IP address, unlike an IP address
set automatically, remains the same if you reboot the Fiery 3850C. You must change
the default to a valid address for your network. For information about setting up
printing with TCP/IP, see Chapter 5.
