Device control
79
7.11.6 Software Version
The following two software versions of the device can be viewed in this section:
•
Firmware (device control)
•
Display (program control)
The current software versions are specified in turn, whereby the firmware is listed first.
7.11.7 Operating Hours
The operating hours of the device in hours and minutes (hh:mm) are displayed in this section.
The process times are counted, i.e. the total times between starting and stopping a grinding
process. The time cannot be manipulated.
7.11.8 Serial number
The serial number of the device can be displayed in this section.
7.11.9 Software Update
The software can be updated using this section.
There must be a suitable USB data carrier in the USB interface.
•
The USB data carrier must be formatted to the FAT32 file system.
•
USB 3.0 data carriers are not supported.
•
Only the software to be installed may be located in the main directory. The device
then automatically detects the new software.
Proceed as follows to update the software:
Press the
symbol to perform an update.
Wait until the transfer and installation have finished.
The dial flashes blue until the touchscreen is restarted. This may take a few seconds.
7.11.10
Service Environment
The service environment can be accessed using this section. The service environment can only
be accessed by service technicians who have been authorised by Retsch GmbH.
If the service environment is selected, the USB interface is activated and "On" displayed
beneath the
symbol. No other functions will be executed, however.
Deactivate the service environment by pressing on the section or exit the "System settings"
menu by pressing the
button.
All other functions remain deactivated while the service environment is activated.
7.11.11
Log file
Using this section a log file of the device can be prepared and saved on a USB carrier. This
function is also used to read out operating hours, error messages and information, and can only
be accessed by service technicians who have been authorised by Retsch GmbH.
Summary of Contents for Mixer Mill MM 500 nano
